What the RER12473 Hardware Set Includes
The Redcat Racing RER12473 is a hardware spare part set that contains 10 pieces of 3x20mm countersunk hex machine thread screws. These screws are designed as a replacement option for compatible Redcat Racing vehicles, specifically the KAIJU and MONTE CARLO models. While the part number may appear in steering servo discussions, the RER12473 itself is a screw set, not a servo unit. It provides the mounting hardware needed to secure or replace a steering servo on these vehicles.
RER12473 Part Details
- RER12473: Type: Countersunk hex machine thread screws, Size: 3x20mm, Quantity: 10 pieces. The 3x20mm size matches typical steering servo mounting points on KAIJU and MONTE CARLO chassis. Having 10 screws gives you extras for other hardware needs or future replacements.

RER12473 - RER12473: Listed compatibility: KAIJU and MONTE CARLO vehicles. These two models are the only ones confirmed by the catalog. If you own a different Redcat vehicle, you need to verify screw length and head type before ordering.
- RER12473: Part number: RER12473, Brand: Redcat Racing. Using genuine Redcat hardware ensures thread pitch and material quality match the original factory screws. Aftermarket screws may have different thread standards.
Step-by-Step RER12473 Steering Servo Installation
These steps assume you are replacing a steering servo on a KAIJU or MONTE CARLO vehicle using the RER12473 screws. Always disconnect the battery before working on your RC.
- Remove the old servo and hardware: Unscrew the existing mounting screws from the steering servo. Keep the removed screws aside for comparison with the new RER12473 screws. Note the screw length and head type.
- Check screw compatibility: Compare one RER12473 screw (3x20mm countersunk hex) against the old screw. If lengths match, proceed. If the old screw is shorter or uses a different head shape, do not force the new screw—it may not seat properly or could damage the chassis.
- Mount the new servo: Place the new steering servo into the chassis mount. Align the screw holes. Insert a RER12473 screw into each hole and tighten with a hex driver. Do not overtighten—countersunk heads can strip if overtorqued.
- Verify servo movement: Reconnect the battery and test steering range. Ensure the servo moves freely without binding. If the screws are too long, they may contact internal gears or the servo case.
What the Catalog Does Not Confirm
The RER12473 listing does not specify thread pitch, material, or recommended torque. While the screws are listed as compatible with KAIJU and MONTE CARLO, the catalog provides no installation instructions or torque specs. If you are unsure about screw length for other models, measure your existing hardware before ordering. The RER12473 is a practical replacement set, but it only covers the hardware—not the servo itself.


