What the Redcat 18013 Set Is
The Redcat 18013 is a spare parts set that includes two tires with foam, designed specifically for the EVEREST-10. It is listed under Spare Parts, Wheels & Tires, so it is meant to replace worn or damaged tires rather than upgrade performance.
Because the set comes with foam already installed, it gives you a direct replacement option without needing to buy foam separately. That is convenient, but it also means you are limited to the compound and tread that Redcat supplies for this part number.
Key Catalog Facts for the 18013
- 18013: Compatible with: EVEREST-10 This is the only confirmed fitment, so verify your vehicle is an EVEREST-10 before ordering.

18013 - 18013: Contents: Tires with foam, 2 pieces You get a pair, which is enough to replace both front or both rear tires on a typical 4-wheel vehicle.
- 18013: Part number: 18013, Category: Spare Parts, Wheels & Tires This is a genuine Redcat Racing spare part, so it should match the original equipment specifications for the EVEREST-10.
How to Replace Tires with Foam on the EVEREST-10
These steps follow the general process for swapping tires on an RC vehicle. The provided catalog does not include a specific installation manual, so use these as practical checkpoints, not manufacturer instructions.
- Remove the wheel from the vehicle: Use the appropriate wrench to loosen the wheel nut. Keep the nut and any washers in a safe place.
- Separate the old tire from the wheel: If the tire is glued, carefully work a flat tool around the bead to break the bond. For foam tires, the foam may be removable separately.
- Insert the new foam and tire: Place the foam inside the new tire, then mount the tire onto the wheel rim. Make sure the bead sits evenly all the way around.
- Reattach the wheel to the vehicle: Slide the wheel back onto the axle, replace the nut, and tighten it securely. Do not overtighten, as that can damage the bearing or hub.
What the Catalog Does Not Confirm
The supplied information does not specify tire diameter, width, compound, or whether the tires are glued or bead-locked. It also does not state if the set is intended for front, rear, or all four positions.
Because of that, the safest assumption is that the 18013 matches the original tires that came with the EVEREST-10. If you are unsure, compare the dimensions and mounting style with your current tires before you buy.


