How to Install Redcat Part RER13480 on Your RC

Quick Answer

To install Redcat part RER13480, remove the wheel and axle, replace the old bearings with the new 3×6×2.5 mm precision ball bearings, and reassemble. This guide covers the process for ASCENT 18 series models.

Installation Steps

1. Remove the Wheel and Axle: Take off the wheel nut and pull the wheel off. Then remove the axle pin and slide out the axle shaft. Keep small parts in a safe container. Common mistake: losing the axle pin. Place it in a tray or magnetic mat.
2. Extract the Old Bearings: Use a small flathead screwdriver or bearing removal tool to gently pry out the old bearing from the wheel hub. Work from the inside edge to avoid damaging the plastic hub. Checkpoint: inspect the hub for cracks or wear before installing new bearings.
3. Install the New RER13480 Bearings: Press one new bearing into the hub by hand or with a socket that matches the outer diameter. Ensure it sits flush. Repeat for the second bearing if the hub holds two. Common mistake: forcing the bearing at an angle. It should slide in straight and level.
4. Reassemble the Wheel Assembly: Slide the axle shaft back through the bearings, insert the axle pin, and reattach the wheel. Tighten the wheel nut securely but avoid overtightening. Checkpoint: spin the wheel by hand to confirm smooth rotation before driving.

Product Facts

• RER13480: The RER13480 includes two precision ball bearings sized 3 × 6 × 2.5 mm, compatible with ASCENT 18 series RC vehicles. These bearings are a direct replacement for worn stock bearings, ensuring smooth wheel rotation and consistent performance.