What the RER41357 Transmission Shaft Set Is
The Redcat Racing RER41357 Transmission Shaft Set is a genuine spare part designed specifically for the Vertex 6 RC vehicle. This set includes one complete transmission shaft assembly, making it a direct replacement for a worn or damaged shaft. It is listed as a spare parts item, not an upgrade or performance modification, so you can expect the same fit and function as the original part.
RER41357 Catalog Facts
- RER41357: Compatible with: Vertex 6 This part is designed exclusively for the Vertex 6 model. Using it on another model may require modifications or may not fit at all.

RER41357 - RER41357: Contents: Transmission Shaft Set (1 set) The set includes one transmission shaft. Ensure you have all necessary fasteners and tools before starting the installation.
How to Install the RER41357 Transmission Shaft
The following steps are based on the part being a direct replacement for the Vertex 6 transmission shaft. Always consult your vehicle's manual for model-specific disassembly procedures.
- 1. Prepare your vehicle: Place the Vertex 6 on a clean, stable work surface. Remove the battery and clean any dirt or debris from the chassis area around the transmission.
- 2. Access the transmission: Remove the body clips and lift off the body. Depending on your configuration, you may need to remove the skid plate or lower chassis brace to access the transmission housing.
- 3. Remove the old shaft: Carefully disconnect any linkages or wires attached to the transmission. Remove the screws or pins securing the old transmission shaft, then slide it out. Note the orientation and any washers or spacers for reinstallation.
- 4. Install the new RER41357 shaft: Insert the new transmission shaft into the housing, ensuring it aligns with the gear mesh. Reinstall any washers or spacers in the same order as the original. Secure with the original hardware, tightening to a snug fit without over-torquing.
- 5. Reassemble and test: Reattach any removed braces, skid plates, and the body. Install the battery and perform a low-speed test to confirm smooth operation. Listen for unusual noises and check for binding before full-throttle use.
What the Catalog Does Not Confirm
The supplied catalog information does not include torque specifications, thread locker recommendations, or detailed disassembly steps for the Vertex 6 transmission. For these details, refer to your vehicle's factory service manual. If you are unsure about any step, consult a local hobby shop or Redcat Racing support.


