What the RER41416 Set Is
The Redcat RER41416 is a set of four screw pins, each measuring 5x17mm. Listed as both a hop-up and a spare part, it is designed specifically for the Vertex 6 platform. If you are maintaining or upgrading the steering knuckle area on that model, these pins are the correct size to replace worn or damaged originals.
RER41416 Catalog Facts
- RER41416: Part number RER41416, set contains 4 pieces, size 5x17mm. You get exactly four pins of the same size, enough for a typical steering knuckle pivot point on a Vertex 6. If your model uses a different pin count or size, this set may not fit without modification.

RER41416 - RER41416: Compatible with: Vertex 6. Redcat confirms fitment only for the Vertex 6. If you own a different RC car, you will need to measure your existing pins or check the manual before ordering.
- RER41416: Category: Hop Ups, Spare Parts. These pins work as a direct replacement for stock parts or as an upgrade. The set is sold as a hop-up, meaning it may offer improved material or finish compared to the original, though the catalog does not specify material differences.
How to Decide If This Set Is Right for You
First, verify that your RC car is a Vertex 6. If it is, the RER41416 pins are the correct length and diameter for the steering knuckle assembly. The set includes four pins, which matches the number typically needed for both sides of the front steering system.
If you are repairing a stripped or bent pin, these are a direct swap. If you are upgrading, the hop-up designation suggests they may be harder or more durable than the factory part, but the catalog does not state the material. Expect a similar installation process to the original pins.
For non-Vertex 6 models, measure your existing pins. If they match the 5x17mm size of the RER41416 screw pins, the part may work, but Redcat only guarantees fitment on the Vertex 6. Without a compatibility list, you assume fitment risk.
What the Catalog Does Not Confirm
The catalog does not specify the material (e.g., steel, stainless, or hardened alloy) or include installation instructions. You will need to reuse the original hardware or follow your Vertex 6 manual for disassembly. The pins are sold without washers or nuts, so check that your existing hardware is reusable.
If you are unsure about fitment on a different model, the safest approach is to contact Redcat support or compare the RER41416 dimensions against your current pins. The 5x17mm size is a common standard, but thread pitch and head style are not listed.


